1 00:00:01,060 --> 00:00:05,000 In this section we're going to assemble the Y-plates. 2 00:00:05,000 --> 00:00:07,920 We'll start by putting the smooth idlers onto your Y-plates. 3 00:00:07,920 --> 00:00:13,100 Insert the screw into the smooth idler from the opposite side that the bearing sticks out of. 4 00:00:13,100 --> 00:00:16,180 Then slide an aluminum spacer onto the screw. 5 00:00:16,180 --> 00:00:20,660 And put it in this hole in the Y-plate. 6 00:00:21,180 --> 00:00:26,360 Fasten it with a Nylock hex nut on the other side. 7 00:00:28,420 --> 00:00:35,220 Repeat this process with the second smooth idler. 8 00:00:38,320 --> 00:00:43,240 You'll note that there are two sizes of holes that accept V-wheels on the Y-plates as well. 9 00:00:43,240 --> 00:00:47,660 A smaller one for Nylock hex nuts, and a larger one for eccentric nuts. 10 00:00:47,660 --> 00:00:50,800 We'll start with the holes that accept the Nylock nuts. 11 00:00:50,940 --> 00:00:55,560 Start by putting a screw through a V-wheel, then put a washer on that screw... 12 00:00:55,560 --> 00:00:58,800 and push it through one of the smaller holes on the Y-plate. 13 00:00:58,800 --> 00:01:03,300 Again, fasten this on the back side with a Nylock hex nut. 14 00:01:04,040 --> 00:01:12,160 Repeat this process for the other top V-wheel. 15 00:01:13,140 --> 00:01:16,660 Now we'll put the bottom V-wheels on. They use eccentric nuts. 16 00:01:16,660 --> 00:01:20,940 First put a screw through a V-wheel, followed by a washer. 17 00:01:21,840 --> 00:01:24,780 Stick that screw through the plate as before. 18 00:01:24,780 --> 00:01:32,600 And then thread an eccentric nut onto the screw. Make sure that the shoulder of the eccentric nut faces the Y-plate. 19 00:01:32,600 --> 00:01:40,200 Repeat this process for the second bottom V-wheel with an eccentric nut. 20 00:01:41,060 --> 00:01:48,440 I'm going to tighten the top V-wheels first. 21 00:01:49,040 --> 00:01:51,820 You'll want to get these a little past finger-tight. 22 00:01:51,820 --> 00:02:01,520 There is no reason to wrench on it really hard, but you do want these to stay in place. 23 00:02:08,720 --> 00:02:11,480 Now I'm going to tighten the eccentric nuts. 24 00:02:11,480 --> 00:02:26,020 Make sure that the shoulder of the eccentric nut is seated inside of the large hole. 25 00:02:32,600 --> 00:02:37,440 You'll want to make another version of the same plate for the other side of the machine. 26 00:02:37,440 --> 00:02:43,240 But make sure that it's a mirrored image. Take a look at this picture for clarification.